Setting Separate Channel Levels For Listening Modes - Pioneer VSX-D712-S Manual De Instrucciones

Setting up
The test tone for channel delay is output in the
same order as step 5:
R C
SW SB
After you have completed all the channels in
your speaker setup, the volume level returns
to normal and COMPLETE, then RESUME
shows in the display.
• Using the MCACC system to set up your
speaker system will overwrite any
previous settings you had for the
STANDARD or ADVANCED SURROUND
modes.
All manuals and user guides at all-guides.com
Setting separate channel
levels for listening modes
LS
In addition to the MCACC setup, you can also
set relative channel levels from the listening
RS
position using the method below. Using CH
SELECT (see tip below), it is also possible to
set separate channel levels for each of the
listening modes.
1
SURROUND.
2
tone.
The test tone is output in the following order
(depending on the speaker setting):
• Default setting: 0 dB
ADVANCED
STANDARD SURROUND
CH
SELECT LEVEL
MASTER
VOLUME
Press STANDARD or ADVANCED
Press TEST TONE to output the test
L C
SW LS
• If you don't hear a test tone from one of
your speakers, please refer to Speaker
setting on page 44 and Surround back
speaker setting on page 45 to make sure
you have correctly specified your speaker
setup.
07
TEST
TONE
R
RS
SB
51
En