Making Recordings; Making An Audio Or A Video Recording - Pioneer VSX-D712-S Manual De Instrucciones

Making recordings

Chapter 9:
Making recordings
Making an audio or a video
recording
You can make an audio or a video recording
from the built-in tuner, or from an audio or
video source connected to the receiver (such
as a CD player or TV).
Keep in mind you can't make a digital
recording from an analog source or vice-
versa, so make sure the components you are
recording to/from are hooked up in the same
way (see Connecting up on page 16 for more
on connections).
If you want to record a video source, you also
need use the same type of connection for the
source as for the recorder. For example, you
can't record a component hooked up to S-
video jacks with a recorder hooked up to the
component video outputs (see page 20 for
more on video connections).
INPUT SELECT
MULTI CONTROL
DVD/LD TV / SAT VCR/DVR TV CONT
C D
CD-R/TAPE TUNER
ADVANCED STEREO/ SIGNAL MIDNIGHT/
STANDARD SURROUND DIRECT SELECT LOUDNESS SPEAKERS
PHONES SURR.
LISTENING MODE
INPUT ATT FL DIMMER
SETUP
MIC DIGITAL IN
All manuals and user guides at all-guides.com
DVD/LD TV/SAT VCR/DVR VIDEO
CD-R/
CD TAPE/MD TUNER AUX
STATION
STANDBY
STANDBY / ON
TUNER EDIT CLASS
MULTI JOG
PHONES
SB CH QUICK
MODE TONE SETUP
MULTI JOG
VIDEO INPUT
S-VIDEO VIDEO L AUDIO R
1 Select the source you want to record.
Use the MULTI CONTROL buttons (or INPUT
SELECT).
2 Select the input signal (if necessary).
Press SIGNAL SELECT (front panel) to select
the input signal corresponding to the source
component (see page 36 for more on this).
3 Prepare the source you want to record.
Tune to the radio station, load the CD, video,
DVD etc.
4 Prepare the recorder.
Insert a blank tape, MD, video etc. into the
recording device and set the recording levels.
Refer to the instructions that came with the
recorder if you are unsure how to do this.
Most video recorders set the audio recording
level automatically—check the component's
instruction manual if you're unsure.
5 Start recording, then start playback of
the source component.
• The receiver's volume, balance, tone
(bass, treble, loudness), and surround
effects have no effect on the recorded
signal.
09
57
En