Programming Signals From Other Remote Controls (Vsx-D812/D912 Only) - Pioneer VSX-D712-S Manual De Instrucciones

Controlling the rest of your system
3 Use the number buttons to enter the
preset code.
You can find the preset codes on page 64
(VSX-D712) and page 65 (VSX-D812/912).
The LED blinks again after you enter the code.
If the correct code has been input the power
of the component being input will turn on or
off.
The power of the component being input will
only turn on or off if that component is able to
be turned on directly by remote control.
• You can only input a code for the compo-
nent type written on each MULTI
CONTROL button (except RECEIVER and
TUNER).
• Even if you don't input a preset code for
the TV (TV/SAT MULTI CONTROL button)
you will be able to control your TV using
the dedicated TV CONTROL on the
remote if you have assigned it to the TV
CONT button.
• You may not be able to use a particular
code even if it is listed on page 64.
• The remote control buttons will not be
able operate other equipment unless
preset with the method above.
4 Repeat steps 2 through 3 to try a
different code, or to enter a code for
another component you want to control.
5 When you're done, press RECEIVER.
Programming signals from
other remote controls
VSX-D812/D912 only
If the preset code for your component is not
available, or the available preset codes do not
operate correctly, you can program signals
from the remote control of another compo-
All manuals and user guides at all-guides.com
nent (for example , , or other operation
buttons). This can also be used to program
additional operations (buttons not covered in
the presets) after assigning a preset code.
1
press and hold the 2 button.
The LED blinks.
2
the component you want to control.
The LED lights.
3
towards each other about 2–5 cm apart
then press the button that will be doing
the learning on this receiver's remote
control.
The LED blinks rapidly.
4
other remote control that is sending
(teaching) the signal to this receiver's
remote control.
If the operation has been learned success-
fully, the LED on this receiver's remote will
blink once then light steadily.
If for some reason the operation hasn't been
learned the LED will blink for three seconds
and then light steadily. If this happens, keep
pressing the (teaching) button as you vary the
distance between the two remotes, until you
see the the LED light steadily.
If there is not enough memory for this button
to be learned by the remote, the LED will blink
twice and the operation will be canceled.
5
current component repeat steps 3 and 4.
To program operations for another compo-
nent exit and repeat steps 1 through 5.
While pressing the RECEIVER button,
Press the MULTI CONTROL button for
• To exit or cancel press RECEIVER.
Point the two remote controls
2 – 5 cm
Press the corresponding button on the
To program additional signals for the
10
59
En