Listening To Multi-Channel Playback - Pioneer VSX-D712-S Manual De Instrucciones

Playing sources
• Press SIGNAL SELECT (front panel) to
select the input signal corresponding to
the source component.
Each press cycles through the options as
follows:
AUTO
DIGITAL
ANALOG
The AUTO setting automatically switches to
DIGITAL if a digital source is detected, other-
wise the signal select will be ANALOG.
DVD 5.1ch (VSX-D712) and DVD 7.1ch (VSX-
D812/D912) will only appear when DVD/LD is
selected.
When set to DIGITAL or AUTO, 2 DIGITAL
lights when a Dolby Digital signal is input,
and DTS lights when a DTS signal is input.
• This receiver can only play back Dolby
Digital, PCM (32kHz–96 kHz) and DTS
digital signal formats (however, only the
VSX-D812 and VSX-D912 can decode DTS
96kHz/24 bit signal formats). With other
digital signal formats, set to ANALOG.
• You may get digital noise when a LD or CD
player compatible with DTS is playing an
analog signal. To prevent noise, make the
proper digital connections (page 17) and
set the signal input to DIGITAL.
• Some DVD players don't output DTS
signals. For more details, refer to the
instruction manual supplied with your
DVD player.
All manuals and user guides at all-guides.com
Listening to multi-channel
playback
DVD 5.1 ch/
DVD 7.1 ch
1
2
3
back.
Use the MULTI CONTROL buttons (or INPUT
SELECT).
4
If the source is Dolby Digital, DTS, or Dolby
Surround encoded, the proper decoding
format will automatically be selected and
shows in the display.
If you are listening to a two channel source,
each press changes the display as follows:
MUSIC
Refer to page 35 for more details about each
mode.
RECEIVER
INPUT SELECT
MULTI CONTROL
DVD/LD TV / SAT VCR/DVR
C D
CD-R/TAPE TUNER
STANDARD
Switch on the playback component.
Turn on the power of the receiver.
Select the source you want to play-
Press STANDARD.
MOVIE
(2 Pro Logic II)
(Neo:6)
CINEMA
(Neo:6)
TV CONT
MUSIC
(2 Pro Logic II)
PROLOGIC
06
37
En