Update Irmware; Change Password; Update Binding Parameter Settings; Install Other Languages - HellermannTyton AT2000 CPK Manual Del Usuario

8.6.1 Update irmware

A irmware update includes an update for the installed
languages.
Latin alphabet have to be updated separately, à "Install Languages such as Asiatic languages that do not use the
other languages" on page 21.
f Click on
Firmware update power
or
f Click on
Firmware update
There are separate *.HEX iles for the AT2000 CPKand the
power pack:
AT2000 CPK: AT2000CPK_Tool_Vxxx
Power pack: AT2000CPK_PowerPack_Vxxx
f Select the appropriate *.HEX ile.
f In the window opened by the operating system, click on
the Open button.
; The
Start upload button appears on the screen.
f Click on
Start upload.
; The new irmware is uploaded.

8.6.2 Change password

The setup specialist's password consists of four characters
and the default setting is 0000. HellermannTyton
recommends setting an alphanumeric password that includes
at least one special character.
f Click on Change.
f Enter the current password and click on
f Enter the new password and click on
f Re-enter the new password and click on
; The password is changed.

8.6.3 Update binding parameter settings

The update for the binding parameter settings is a *.BIN
ile.
f Click on
Load from file.
f Select the appropriate *.BIN ile.
There are separate *.BIN iles for updating the binding
parameter settings and adding additional languages.
f In the window opened by the operating system, click on
the Open button.
; The name of the ile appears in
f Click on
Send to tool.
; The new binding parameters are uploaded to the
AT2000 CPK.
; The progress bar shows progress of the data transfer in
percent (%).
Operating Instructions • AT2000 CPK • 02-2017 • v02 • 106-29004
pack.
tool.
OK to conirm.
OK to conirm.
OK to conirm.
File loaded.

8.6.4 Install other languages

Function for updating languages such as Asiatic
languages, for example, that do not use the Latin
alphabet.
f Click on
Load from file.
f Select the appropriate *.BIN ile.
There are separate *.BIN iles for updating the binding
parameter settings and adding additional languages.
f In the window opened by the operating system, click on
the Open button.
; The name of the ile appears in
Languages-Index8.bin).
f Click on
Send to tool.
; The new languages are uploaded to the AT2000 CPK.
; The progress bar shows progress of the data transfer in
percent (%).
HT Data Management
File loaded ("More_
21