HellermannTyton AT2000 CPK Manual Del Usuario página 285

DISPLAY MESSAGE
Position of tie advancer
1. Operate bandoleer cutter
2. Open gate
Position of tie advancer
1. Press Reset button
2. Check position of tie advancer
Position of tie advancer
Close gate
Error, drum
1. Operate bandoleer cutter
2. Open gate
Error, drum
1. Remove cable-tie residues
2. Press Reset button
Operating Instructions • AT2000 CPK • 02-2017 • v02 • 106-29004
POSSIBLE CAUSE
• No tie advancer present.
• The tie advancer is faulty.
• The cable tie bandoleer is
pulled in at an angle.
• Roller lever drum is jammed
or is defective.
SOLUTION
f Push actuator for bandoleer cutter to the left.
f Open the gate.
; Position of tie advancer appears as the
next message on the display.
f If applicable, carefully remove the cable-tie residues.
f Press the Reset button.
f Open the roller block, à "Checking tie advancer" on
page 31.
f Check the tie advancer; replace if necessary.
; Position of tie advancer appears as the
next message on the display.
f Close the gate.
f Push actuator for bandoleer cutter to the left.
f Open the gate.
f Open the two transparent laps at the gate,
à "Troubleshooting a cable-tie bandoleer
malfunction" on page 28.
; Error, drum appears as the next message on the
display.
f If applicable, carefully remove the cable-tie residues.
f Open the roller lever drum and turn the drum to the
correct position.
f Press the Reset button.
; Error, gate appears as the next message on the
display.
f Close the gate.
f Load a new cable tie bandoleer, à "Loading cable
ties" on page 11.
Troubleshooting
26