Wilo EMU TR 212 Instrucciones De Instalación Y Funcionamiento página 22

en-US
6.4.2 Installation with lowering device
1
8
7
6
5
Fig. 4: Prepare the mixer
22
Installation and electrical connection
9. Clean the fill opening screw plug, replace the seal ring and screw it back in. Max. tight-
ening torque: 8 Nm (5.9 ft·lb)!
10.Reapply corrosion protection: Seal screw plug, e.g. with Sikaflex.
The mixer is lowered into the basin using a lowering device. The lowering device's guide pipe
leads the mixer safely to the operating point. The resultant reaction forces are transferred
via the lowering device directly into the foundation. The foundation must be dimensioned
to bear this load!
CAUTION! Material damage due to incorrect accessories! Due to the high reaction forces,
the mixer may only be operated with the manufacturer's accessories (lowering device
and frame). If the mixer is ordered for installation with a lowering device, the frame
comes pre-assembled. If the mixer is delivered without a frame, order the appropriate
frame from customer service!
Preparatory tasks
1 Hoist
2 Lifting equipment
3 Shackle for attachment
4 Propeller
5 Pedestal for secure set-down
2
6 Support block for aligning
3
7 Frame
8 Cable brackets for strain relief
‡
Mixer set down and positioned horizontal.
4
‡
Frame mounted on the mixer.
‡
Lowering device mounted in basin.
‡
Hoisting gear with sufficient bearing capacity is available.
1. Attach lifting equipment to frame with a shackle.
2. Mount propeller. See separate installation instructions on installing the blades.
3. Version with plastic rollers: Loosen linchpins and dismantle plastic rollers and quick-re-
lease axles.
NOTICE! Prepare components for further installation.
4. Lay all connection cables.
5. Mount the cable bracket for the cable anchoring on the edge of the basin.
CAUTION! In case of powerful flows in the basin, install the "additional rope anchor-
ing"!
WILO SE 2021-05