Wilo EMU TR 212 Instrucciones De Instalación Y Funcionamiento página 42

en-US
9.6.5 Replacing the handle grip
4
6
1
2
Fig. 14: Replacing handle grip
42
Maintenance and repair
1 1x frame fixation material: hex screw, 2x washers, hexagon nut
5
2 Frame
3 2x mixer fixation material: hex screw, washer
4 Handle grip
3
5 Shackle
6 Cable bracket fixation: washer, hexagon nut
‡
Mixer set down on a firm surface and secured.
‡
Tools are ready for use.
1. Disassembling cable brackets:
- Undo and unscrew the hexagon nut.
- Pull off the washer from the hex screw.
2. Undoing the handle grip fixation on the frame:
- Undo and unscrew the hexagon nut.
- Pull off the washer from the hexagon head screw.
- Pull out the hex screw.
3. Undoing the handle grip fixation on the mixer: undo and unscrew the hex screw.
4. Remove the handle grip.
5. Place a new handle grip and secure it to the frame using the fixation:
- Position the washer on the hex screw.
- Insert the hex screw through the frame and handle grip.
- Position the washer and screw on the hexagon nut.
NOTICE! Only slightly tighten the fixation! Do not fully tighten the handle grip!
6. Securing the handle grip on the mixer:
- Position the washer on the hex screw.
- Coat the hex screw with thread-locking fluid.
- Screw in the hex screw and fully tighten it. Max. tightening torque: see Appendix.
7. Compare the drilling pattern of both handle grip struts with the drilling pattern of the
old handle grip. If necessary, adapt the drilling pattern of the new handle grip.
8. Securing the handle grip on the frame:
- Undo the hexagon nut.
- Coat the hex screw with thread-locking fluid.
- Fully tighten the hexagon nut. Max. tightening torque: see Appendix.
9. Installing cable brackets:
- Insert cable bracket into handle grip. NOTICE! The cable must be routed in a small
arc. Do not route the cable under tension!
- Position the washers on the hex screws.
- Screw on and fully tighten the hexagon nut. Max. tightening torque: see Appendix.
10.Check the shackle position!
Attach the lifting equipment to shackles. The mixer must remain horizontal during lift-
ing. Move shackles if the mixer tilts.
▶ Handle grip changed.
WILO SE 2021-05