Wilo EMU TR 212 Instrucciones De Instalación Y Funcionamiento página 23

2
±0
9
Fig. 5: Swivel the mixer over the basin
7
Fig. 6: Mixer on the lowering device
Installation and operating instructions Wilo-EMU TR/TRE 212 ... 326-3
Installation and electrical connection
Lift the mixer and swivel it over the basin
1 Hoist
1
2 Lifting equipment
7 Frame
9 Guide pipe for lowering device
‡
Preparatory tasks completed.
1. Lift mixer so that it can be swiveled safely over the railings.
NOTICE! The mixer must be suspended horizontally from the hoisting gear. If the
mixer hangs at an angle to the hoist, adjust the attachment point on the frame.
2. Pivot the mixer over the basin.
7
NOTICE! The frame must be perpendicular to the guide pipe. If the frame is not per-
pendicular to the guide pipe, adjust the reach of the hoist.
Mounting mixer on the lowering device
7 Frame
9 Guide pipe for lowering device
10 Upper holder of the lowering device
10
‡
Mixer hangs horizontally.
‡
Frame perpendicular to the guide pipe.
‡
Cable bracket mounted on the edge of the basin.
1. Slowly lower the mixer.
2. Insert the guide pipe in the frame without tilting.
NOTICE! The guide rollers are in contact with the guide pipe.
3. Version with quick-release axles:
9
Lower mixer until the frame is below the upper holder. Install the quick-release axles
and plastic rollers and secure them with linchpins!
en-US
23