Roland JP-8080 Manual Del Usuario página 196

Tabla de contenido

Publicidad

* When All Note Off is received, all currently sounding notes of the corresponding
channel will be turned off. However if Hold 1 is on, the sound will be held until these
are turned off.
Omni Off
(Controller number 124)
status
2nd byte
3rd byte
BnH
7CH
00H
* The same processing as when All Note Off is received will be done.
Omni On
(Controller number 125)
status
2nd byte
3rd byte
BnH
7DH
00H
* The same processing as when All Note Off is received will be done.
Mono
(Controller number 126)
status
2nd byte
3rd byte
BnH
7EH
mmH
mm=Mono number:
00H - 10H (0 - 16)
* The same processing as when All Note Off is received will be done, and the MONO
Switch parameter will be set to ON.
Poly
(Controller number 127)
status
2nd byte
3rd byte
BnH
7FH
00H
* The same processing as when All Note Off is received will be done, and the MONO
Switch parameter will be set to OFF.
System Realtime messages
Active Sensing
status
FEH
* When an Active Sensing message is received, the unit will begin monitoring the
intervals of all further messages. During monitoring, if more than 400 ms passes
without a message being received, the same processing will be done as when All
Sound Off, All Note Off, and Reset All Controllers messages are received. Then
monitoring will be halted.
Timing Clock
status
F8H
* This is received when MIDI Sync ([MIDI]) is set to MIDI IN.
Start
status
FAH
* This is received when MIDI Sync ([MIDI]) is set to MIDI IN.
Continue
status
FBH
* This is received when MIDI Sync ([MIDI]) is set to MIDI IN.
Stop
status
FCH
* This is received when MIDI Sync ([MIDI]) is set to MIDI IN.
System Exclusive messages
* When MIDI Thru is ON (ALL), messages arriving at MIDI IN will be re-transmitted
from MIDI OUT without change.
* These are not received when Rx Exclusive SW ([MIDI]) is OFF.
status
data byte
status
F0H
iiH, ddH, ......, eeH
F7H
F0H:
System Exclusive message status
ii = ID number:
This is the ID number (manufacturer ID) that specifies the
manufacturer whose exclusive message this is. RolandÕs manufacturer
ID is 41H. ID numbers 7EH and 7FH are defined in an expansion of the
MIDI standard as Universal Non-realtime messages (7EH) and
Universal Realtime Messages (7FH).
dd,..., ee = data:
00H - 7FH (0 - 127)
F7H:
EOX (End Of Exclusive)
Data Request 1 RQ1
This message requests the other device to transmit data. The address and size indicate the
type and amount of data that is requested.
When a Data Request message is received, if the device is in a state in which it is able to
transmit data, and if the address and size are appropriate, the requested data is
transmitted as a Data Set 1 (DT1) message. If the conditions are not met, nothing is
transmitted.
status
data byte
F0H
41H, dev, 00H, 06H, 11H, aaH, bbH,
ccH, ddH, ssH, ttH, uuH, vvH, sum
Byte
Remarks
F0H
Exclusive status
41H
ID number
(Roland)
dev
device ID
(dev: 10H - 1FH, factory setting is 10H)
00H
model ID
(JP-8080)
06H
model ID
(JP-8080)
11H
command ID
(RQ1)
aaH
address MSB
bbH
address
ccH
address
ddH
address LSB
ssH
size MSB
ttH
size
uuH
size
vvH
size LSB
sum
checksum
F7H
EOX
(End Of Exclusive)
* The size of data that can be transmitted at one time is fixed for each type of data, and
data requests must be made with a fixed starting address and size. Refer to the address
and size given in Ò 4. Parameter address map Ò (p.200)
* For details on the address, size, and checksum values, refer to ÒExamples of exclusive
messages and calculating the checksumÓ (p.206).
Data Set 1
DT1
This message transmits the actual data, and is used when you wish to set the data of the
receiving device.
status
data byte
F0H
41H, dev, 00H, 06H, 12H, aaH, bbH,
ccH, ddH, eeH, ... ffH, sum
Byte
Remarks
F0H
Exclusive status
41H
ID number
(Roland)
dev
device ID
(dev: 10H - 1FH, factory setting is 10H)
00H
model ID
(JP-8080)
06H
model ID
(JP-8080)
12H
command ID
(DT1)
aaH
address MSB
bbH
address
ccH
address
ddH
address LSB
eeH
data: The actual data to be transmitted. Multi-byte data is transmitted in the
order of the address.
:
:
ffH
data
sum
checksum
F7H
EOX
(End Of Exclusive)
status
F7H
status
F7H
195

Publicidad

Tabla de contenido
loading

Tabla de contenido