Tabla de contenido
Publicidad
Modelo: JP-8080
Implementado
192
Fecha: 16 del 4 de 1998
M I D
Versión: 1.00
------------------------------------------------------------------------------------------------------------------------
Mark
Meaning
n:
MIDI channel
vv:
Value, Velocity etc.
kk:
Note Number
xx:
ON/OFF
------------------------------------------------------------------------------------------------------------------------
1. MIDI messages received at MIDI IN
Channel voice messages
* When MIDI Thru ([MIDI]) is other than OFF, MIDI messages arriving at MIDI IN will
be re-transmitted from MIDI OUT.
Note Off
status
2nd byte
3rd byte
8nH
kkH
vvH
9nH
kkH
00H
* Notes of the part whose Part MIDI Ch ([PART]) matches the MIDI channel of the
received note-off will be turned off.
* When the Individual Trigger Switch ([PFM COMMON]) is ON, and if MIDI channel
number of received Note Off is coincident with Triger Source Channel ([PFM
COMMON]), and also the Note Number of received Note Off is coincident with
Trigger Source Note ([PFM COMMON]), the Envelope of Trigger Destination ([PFM
COMMON]) will be released.
Note On
status
2nd byte
3rd byte
9nH
kkH
vvH
* Notes of the part whose Part MIDI CH ([PART]) matches the MIDI channel of the
received note-on will be sounded.
* When the Individual Trigger Switch ([PFM COMMON]) is ON, and if MIDI channel
number of received Note On is coincident with Triger Source Channel ([PFM
COMMON]), and also the Note Number of received Note On is coincident with
Trigger Source Note ([PFM COMMON]), the Envelope of Trigger Destination will be
started.
Control Change
* If Control Up/Control Down ([MIDI]) is set to a control change, this will function as
controller up or down for the part whose Part MIDI CH ([PART]) matches the MIDI
channel of the received control change message.
* If Tx/Rx Edit SW ([MIDI]) is ON and Tx/Rx Edit Mode ([MIDI]) is set to MODE2, the
Tx/Rx Setting ([MIDI]) setting will be valid. This will affect the value of the parameter
which is assigned to the control change that was received by the part whose Part MIDI
CH ([PART]) matches the MIDI channel of the received control change.
* Tx/Rx settings ([MIDI]) can be made for controller numbers 1 to 31 and 33 to 95. Refer
to Transmit/Receive Setting List (p.188) for the default settings.
Bank Select
status
2nd byte
3rd byte
BnH
00H
mmH
BnH
20H
llH
mm,ll=Bank number:
00 00H - 7F 7FH (bank.1 - bank.16384)
* This is received only when Tx/Rx ProgChg SW ([MIDI]) is BANK SEL + PC.
* If this is received on the Perform Ctrl CH ([MIDI]), it will specify the performance
bank. If this is received on the Part MIDI CH ([PART]), it will specify the patch bank
for that part. If the Perform Ctrl CH and the Part MIDI CH are the same, it will specify
only the performance bank.
* Bank Select processing will be suspended until a Program Change message is received.
Range
0H-FH (ch.1 - ch.16)
00H-7FH (0 - 127)
(Only for note-on velocity, this will be 01H-7FH (1 - 127).)
00H-7FH (0 - 127): C-1 - G9
00H-3FH (0 - 63): OFF
40H-7FH (64 - 127): ON
(Controller number 0, 32)
Publicidad
Tabla de contenido
