Grundfos Conex DIA-2Q Manual De Instrucciones página 32

Ocultar thumbs Ver también para Conex DIA-2Q:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 156
11.5.4 Setting the measuring ranges for chlorine,
chlorine dioxide, ozone, peroxide,
peracetic acid, pH, redox
In the "measuring ranges" menu, the corresponding
measuring ranges are assigned to the measured
values which have been selected in the "parameters"
menu.
In the "measuring ranges" menu, the following
options are available:
– standard measuring ranges
– "others."
See section
8.4 Measuring
The measuring ranges for temperature can be
defined in °C (Celsius) or in °F (Fahrenheit).
The "temperature" submenu is only shown
if the temperature measurement has been
Note
switched on in the "parameter" menu, or if
parameter pH has been selected.
11.5.5 Controller parameters 1/2
See section
11.6 Selection, configuration and
parameterisation of the controller
the controllers.
11.5.6 Water sensor
In the "wat. def. sensor" menu, the water sensor can
be switched on/off.
In the event of sample-water deficiency, the following
will occur:
The malfunction-indicating relay is activated, and
the alarm message "fault water sensor" is
triggered.
With devices with control functions, the actuators
are switched to passive or closed.
The water sensor must be switched on for
Caution
the measuring cell AQC-D2/-D12!
32
ranges.
in order to adjust
11.5.7 Setting the current time (date/time/summer
time)
1. Switch from the "setup" menu to the "date/time"
menu.
time set
01 : 18 : 40 pm
time
Fig. 29
Time setting
2. Set the device to the current time in the "time set"
menu in the format hh.mm.ss.
– Press [OK] to switch to the next number field.
The number field which is currently activated
flashes.
– Alter the settings by pressing the [Up] and
[Down] buttons.
– Pressing the buttons continuously makes the
adjustment dynamically faster.
3. Set the device to the current date in the "date"
menu in the format mm.dd.yyyy with English as
operating language or the format dd.mm.yyyy for
all other languages similarly to the adjustment of
time. The corresponding day of the week
(Mo...Su) is displayed automatically.
4. If necessary, enter the beginning and end date of
the summer time, the kind of time shift and the
number of hours of the time shift.

Publicidad

Tabla de contenido
loading

Tabla de contenido