Establishing The Plug Connection; Control Unit Extension Cable - Rohde ELS Serie Manual De Instrucciones Original

Optionally and depending on the equipment of the kiln, a 19-pin plug-in screw connection with a bayonet lock
(CPC-19) can also be used.
Kiln socket CPC-19
Figure 12: 19-pin socket & plug (optional)
7.3.1.

Establishing the plug connection

Step Description
1 Insert the plug of the control unit into the socket on the kiln.
The plug and socket have a geometric coding - the plug and socket only
2
fit into one another in one position.
The wide lug on the plug must be at the top in the 12 o'clock position to
3
fit into the wide recess on the plug, also in the 12 o'clock position.
You may have to twist the plug a little until it clicks into the socket
4
completely.
5 Tighten the outer screw ring on the plug clockwise.
Table 19: Connecting the control unit
7.3.2.

Control unit extension cable

• If the bracket for the control unit is attached at the operation location (near the kiln), the cable can be extended
using an extension cable.
• The extension cable for the control systems is optionally available in lengths of 2.5, 5 or a maximum of 10
meters.
• Note on EMC:
To meet Electromagnetic Compatibility requirements the controller lead should not exceed 3 m in length. The
instrument is mainly designed for use in Domestic, Commercial and Light Industrial environments where
electromagnetic interference may cause a loss of accuracy of the displayed temperature reading of up to 3°C.
Controller plug CPC-19
98 / 492 - EN -
Plug view
Standard CPC-14
Optional CPC-19
*Both views are seen from the
front of the contacts, in the
direction of the cable outlet!