Adjusting The Angle Of Inclination Of The Els Kiln Floor - Rohde ELS Serie Manual De Instrucciones Original

6.2.5.

Adjusting the angle of inclination of the ELS kiln floor

The angle of inclination of the ELS kiln floor can also be fine-tuned after it has been attached to the floor or on very
uneven floors.
⇒
This activity is usually not required because the floor at the operating location should be prepared accordingly.
Step Description
1
Put a spirit level on the kiln floor.
2 Loosen the bolts of the bearing on the lower guide roller.
3 There is an elongated hole behind the bearing for adjusting
the bearing position.
4 Loosen the locknut of the adjusting screw.
5 The position of the bearing unit is changed by turning the
screw in or out.
Remark
Tool:
Spirit level
Tool:
Loosen the bolts by a maximum of 2-3
turns.
Factory setting = middle position
Tool:
Spanner
Tool:
Spanner
92 / 492 - EN -
• Spanner or socket wrench
• Allen key