Unpacking The Kiln; Disposal Of Packaging; Setting Up; Operating Location - Rohde ELS Serie Manual De Instrucciones Original

Reinforcing braces
Figure 3: Transporting the kiln
5.3.

Unpacking the kiln

NOTE
Be sure to remove all packaging materials such as cardboard boxes, protective films and
adhesive tapes that were used to protect the kiln.
5.4.

Disposal of packaging

Take the wooden, cardboard and film packaging to an appropriate disposal point and help actively promote
environmental protection. For more information on how to dispose of the packaging, please contact your local
authority.
6.

Setting up

6.1.

Operating location

⇒ Minimum requirements for the operating location of the kiln:
-
Sufficient distance of at least 50 cm from walls, other plant and machinery and traffic routes
-
Floor, ceiling insulation, walls, partitions, cladding etc. must be made of flame-retardant material.
-
Sufficient distance from flammable objects
-
Sufficient distance from sprinkler systems
-
Sufficient distance from machines or systems with strong EMC radiation (impairment of the control
system)
⇒ The kiln:
-
may only be set up in a well-ventilated room.
-
must not be operated in rooms with flammable material.
-
must be set up on a non-flammable surface.
-
must not be installed in garages, summer houses, covered terraces or balconies or boiler rooms.
Tines, lifting unit, industrial truck
89 / 492 - EN -
Kiln door closed
and locked
ELS floor
completely
retracted