Fein WPO 13-15 E Manual Del Usuario página 15

3 41 01 061 06 0.book Seite 15 Mittwoch, 12. Juli 2006 8:02 08
WPO 13-15 E / WPO 13-15 IE
mastered in the best possible way. The operator
can master the starting torque and kickback
forces if suitable precautionary measures are
taken.
Never place your hand near the rotating polishing
accessory. The polishing accessory may kick
back over your hand.
Do not position your body in the area where the
power tool will move if kickback occurs. Kickback
will propel the power tool in the direction
opposite to the polishing accessory's movement
at the point of snagging.
Take special care when machining corners, sharp
edges, etc. Prevent the polishing accessory from
bouncing off or tilting. Corners, sharp edges or
bouncing have a tendency to snag the rotating
polishing accessory and cause loss of control or
kickback.
Do not attach a saw chain, wood-carving blade or
circular saw blade. Blades of this kind cause fre-
quent kickback or loss of control over the
power tool.
Safety instructions, particularly for sanding
work with a sanding disc.
When sanding, do not use an excessively over-
sized sanding disc. Follow the manufacturer's rec-
ommendations when selecting sanding discs.
Sanding discs larger than the backing pad present
a laceration hazard; they can tear, cause snag-
ging, rip off from the backing pad or cause kick-
back.
At a glance.
The following numbering used for the
operating elements relates to the figures at
the beginning of this Instruction Manual.
1 Locking button
Lock the drive when changing the polishing
accessory.
2 Push button for starting/stopping
For switching the power tool On and OFF.
3 Switchpad (2x)
To increase the speed.
4 Speed display
Display with symbols showing the different
speed levels.
5 Switchpad (2x)
Reducing the speed.
6 Gear housing cove
Hold the power tool with both hands.
7 Auxiliary handle
Hold the power tool with both hands.
8 Standard accessories
Auxiliary handle (8a),
Gear housing cover (8b).
Only part of the accessories described or shown
in this instruction manual will be included with
your power tool.
Intended use of the power tool.
This power tool is intended as a hand-guided
polisher for commercial use, for polishing jobs
with suitable polishing agents in weather-pro-
tected environments using the application tools
and accessories recommended by FEIN.
Operate the power tool only with the voltage
rating as printed on the nameplate of the
machine.
This machine is also intended to be powered by
a.c. generators with sufficient power output that
correspond with ISO 8528, design class G2.
Compliance with this Standard in particular is
not given when the so-called distortion factor
exceeds 10%. When in doubt, inform yourself
about the generator in use.
Operating instructions.
Mounting the auxiliary handle (Figure 7).
Screw the auxiliary handle tightly onto
the left or right side of the power tool,
depending on the working method. For this,
remove the respective screw of the gear housing
cover.
Mounting the gear housing cover (Figure 6).
Attach the gear housing cover onto the
gear head and tighten with the two screws.
Changing the tool.
Attaching or changing the polishing accessory.
Only press the locking button (1) when
the motor is not running.
EN
15