Description Of The Unit; Initial Startup - Kärcher 4.762-584.0 Manual De Instrucciones

WARNING
● The device is not intended for
use by children, persons with
restricted physical, sensory or
mental abilities or persons un-
familiar with these instructions.
● Only people who have been
instructed on how to use the
device, or have proven their
ability to operate it, and have
been explicitly instructed to
use it, must use the device.
● Do not touch the rotating roller
brush with your fingers.
● Wear suitable protective
gloves, safety goggles, protec-
tive clothing and sturdy shoes
when working.
● Keep the work area clear of
bystanders, children and ani-
mals while using the device.
● Children must be supervised
to prevent them from playing
with the appliance.
● Make sure to stand safely dur-
ing cleaning work.
CAUTION
● Check the device with the
equipment prior to each use to
make sure it is safe and working
correctly. Only use the device
when it is in a correct condition.
ATTENTION
● Observe the warranty condi-
tions of the solar module man-
ufacturer.
● Risk of breakage! Do not walk
on any solar modules. Recom-
mendation: Preheat the water
at high exterior temperatures
(40 °C) to avoid tension in the
glass due to high temperature
differences. It is better to clean
the solar modules when they
are not exposed to the sun.
● Check the solar modules for
damage (cracks, scratches,
leaks, etc.) before cleaning.
Damaged solar modules must
not be cleaned.
● Do not clean solar modules
with dirty and dry brushes as
there is a risk of damage. Al-
ways keep the bristles free of
dirt or sand. Do not damage
the solar module surfaces by
hitting or scratching them with
the cleaning brush. Do not
push the brushes over dry
modules. Do not carry out
cleaning work at sub-zero tem-
peratures.

Description of the unit

Illustration A
Connection for spray lance / telescopic rod (inner
1
thread M18x1.5 with hexagon socket)
Nozzle bar
2
Cleaning brush (not in scope of delivery, see list of
3
accessories)
High-pressure nozzle (035, 045, 060, 080)
4
Allen key
5
Lock
6
Drive of the rotating roller brush
7
Mounting the cleaning brush
1. Press the locking mechanism on the lock together
and turn the lock anticlockwise (approx. 5 turns, re-
grasping necessary). Take off the lock.
2. Push the cleaning brush onto the guide so that the 3
inclined rows of bristles are on the outside.
3. Fit the lock and turn it clockwise until it stops (ap-
prox. 5 turns) (brush engages).
English

Initial startup

11