Eu Certificate Of Conformity - Brill 380 ASM Manual Del Usuario

Problem
Yellow lawn.
Cut not clean.
If you have any other problems
with your Accu Hand Lawn-
mower, please contact Brill
Customer Service or return the
defective unit with a short de-
scription of the problem and,
in case of guarantee, with the
appropriate guarantee docu-
ments to one of the service
centres listed in this leaflet.

EU Certificate of Conformity

The undersigned
Brill Gartengeräte GmbH, Därmannsbusch 7, D-58456 Witten
hereby certifies that, when leaving our factory, the unit indicated below is in accordance with the
harmonised EU guidelines, EU standards of safety and product specific standards.
This certificate becomes void if the unit is modified without our approval.
Description of the unit :
Accu Hand Lawnmower /
Charger
Type :
380 ASM / LG 24
Art. no.:
65035 / 11917
EU directives :
Machinery Directive
98 / 37 / EC
Electromagnetic Compatibility
89 / 336 / EC
Low Voltage Directive
73 / 23 / EC
Directive 93 / 68 / EC
Directive 2000 /14 / EC
Possible cause
Battery power too low for
cutting height.
Cutting height too low.
Cutting gap between cutting
cylinder and bottom blade
is too wide.
Blades are blunt or damaged.
We would draw attention to
the fact that, under the product
liability legislation, we are not
liable for loss or damage caused
by our products when such are
caused by improper repairs or
when during an exchange of
parts such parts are used which
Harmonised
European standards :
EN 292 -1
EN 292 - 2
EN 836
EN 6100 - 3 - 2
EN 6100 - 3 - 3
EN 50338
EN 55014 -2
EN 55014 -1
EN 60335 - 2 - 29 : 88
EN 61558 - 2 - 6 : 97
Remedy
Increase the cutting height and
cut the lawn in stages or charge
the accu (see chapter 8.2. "The
PowerAccu").
Increase the cutting height.
Readjust cutting tool (refer to
section 8.4.).
Have the blade replaced at a
Brill Service Centre or by an
authorised specialist.
are not manufactured by or ap-
proved by ourselves, and the re-
pairs are not carried out by an
authorised Brill service centre or
an authorised specialist dealer.
The same restrictions also apply
for supplementary and accessory
parts.
Guaranteed
noise power level L
:
WA
86 dB (A)
Measured
noise power level L :
WA
82,2 dB (A)
Year of CE marking :
2002
Witten, 02.04.2002
Edgar Heilmann
Geschäftsführer
GB
27