Kit Assembly - Metra 95-5850B Instrucciones De Instalación

ISO DDIN radio provision
Attach the radio brackets to the radio
1.
using the screws supplied with the
radio. (Figure A)
Locate the factory wiring harness and
2.
antenna connector in the dash, and
complete all necessary connections to
the radio. Metra recommends using the
proper mating adapter from Metra and/
or AXXESS. Test the radio for proper
operation.
3. Remove (4) screws in the dash cavity,
then secure the completed assembly
into the dash using those screws.
(Figure B)
Snap the radio trim panel over the
4.
completed assembly, then reassemble
the dash in reverse order of disassembly
to complete the installation.

KIT ASSEMBLY

(Figure A) (Figure B)
REV. 7/19/2021 INST95-5850B
3