Led Indicator For Operating Mode And Mode Change; Led Numeric Display (2 Digits) - Garant SG1 Manual De Uso

3.2.2 LED indicator for operating mode and mode change

DE DE
EN
FR FR
IT IT
Fig. 4: Operating mode: Five automatic modes and one manual mode are available
The current operating mode setting is indicated by a LED.
Switching mode:
ES ES
Press the MODE button until the LED lights up
Use the "+" and "-" buttons to select the desired mode
Press the MODE button until the LED goes out

3.2.3 LED numeric display (2 digits)

CZ CZ
Directly after the unit has been switched on:
 Displays the programme version of the control panel (5 seconds duration, during which the "SL" LED
lights up)
 Displays the programme version of the generator (5 seconds duration, during which the "V" LED lights
up)
PL PL
 Switches to the mode which was set when the unit was switched off.
 Selects of the diameter / of the manual power which was set when the unit was switched off.
The unit is now ready to perform shrink fitting.
After display of the version, normal operation:
RU RU
 Automatic modes (SL, N, V, SC)
The display shows:
Before heating, the selected tool diameter in mm
During heating, the time remaining for the generator in seconds
 Manual mode (MAN)
ZH ZH
The display shows:
Before heating, the selected heating power as a percentage
During heating, the heating time elapsed in seconds
Fault condition:
 In a fault condition an error number is displayed (see "Troubleshooting").
38
SL Slim chucks
N Standard chucks
V Reinforced chucks
SC Shrink collet chuck: Shrink in
SC Shrink collet chuck: Remove
MAN Manual shrink fitting