Confi Guration Of The Sg1; Confi Guring The Boost Factor (Additional Time); Confi Guring The Spray Cooler; Adjusting The Vee Block - Garant SG1 Manual De Uso

3.3 Configuration of the SG1
3.3.1 Configuring the boost factor (Additional time)
After the Additional time button has been pressed, the boost factor increases the heating time of the
automatic modes. Its value can be configured between 0 % and 25 %.
Example: If the boost factor is set to 10 shown on the numeric display, the heating time of an automatic
mode cycle is increased by 10 % if the LED of the Additional time button is lit up during the heating.
Switch the SG1 off.
Switch the unit on.
Whilst the programme version of the control panel is displayed (while the "SL" LED is lit)
press the Additional time button.
Use the + and – buttons to set the boost factor (0 = 0 % to 25 = 25 %).
Press the START/STOP button to return the SG1 into its normal operating condition.
3.3.2 Configuring the spray cooler
The optional spray cooler is started manually and stopped automatically. Its running time can be set to a
value between 0 and 99 seconds (recommended value: 30 seconds).
The spray cooler can be stopped before this time has elapsed by pressing the Cooling button. Opening
the cooler door also switches the spray process off.
Switch the SG1 off.
Switch the unit on.
Whilst the programme version of the control panel is displayed (while the "SL" LED is lit)
press the "Cooling" button.
Use the "+" and "-" buttons to set the running time of the spray cooler.
Press the "START/STOP" button to return the SG1 into its normal operating condition.

3.3.3 Adjusting the Vee block

Fig. 5:
The positioning Vee block ensures that a chuck is in the correct shrink fitting position
as soon as the tool basic chuck rests against the stop in the positioning Vee block.



www.hoff mann-group.com

Positioning Vee block

Positioning Vee block
retaining screw.

Position of the tool base
holder.
DE DE
EN
FR FR
IT IT
ES ES
CZ CZ
PL PL
RU RU
ZH ZH
39