Garant SG1 Manual De Uso página 42

To adjust this, proceed as follows:
DE DE
EN
FR FR
IT IT
ES ES
Fig. 6: Coil raised, in the diagram shown with an optimally centred tool.
CZ CZ
Insert a tool with a small diameter and appropriate screening plate.
Carefully lower the coil and centre the tool to it.
If the tool holder is now against the stop of the positioning Vee block, the Vee block is set at the right
position.
PL PL
Otherwise:
Slacken the positioning Vee block retaining screw.
Move the positioning Vee block so that the tool holder rests precisely on the stop
when the tool is optimally centred.
RU RU
Tighten the positioning Vee block retaining screw again.
ZH ZH
40