3A: Connecting The Audio Components - Sony HT-DDW1500 Manual De Instrucciones

3a: Connecting the audio components

How to hook up your
components
This section describes how to hook up your
components to this receiver. Before you begin,
refer to "Component to be connected" below
for the pages which describe how to connect
each component.
After hooking up all your components,
proceed to "4: Connecting the antennas" (page
29).
Component to be connected
Component With
Super Audio Multi-channel audio
CD player/CD output
player
Analog audio output
b)
only
MD deck/Tape Analog audio output
b)
deck only
a)
Model with MULTI CH OUTPUT jacks, etc. This
connection is used to output audio decoded by the
component's internal multi-channel decoder
through this receiver.
b)
Model equipped only with AUDIO OUT L/R
jacks, etc.
18 GB
Page
19
a)
20
20
Audio input/output jack to be
connected
The sound quality depends on the connecting
jack. Refer to the illustration that follows.
Select the connection according to the jacks of
your components.
Digital
FRONT
MULTI CH IN
Analog
L
High
quality
CENTER
sound
R
SUB
SURROUND WOOFER