BH FITNESS G-238 Manual De Instrucciones página 7

ELECTRONIC MONITOR
MAINS CONNECTION
Insert the jack (Z) for the transformer
into the connection hole (R) on the
main body (bottom, rear of the
machine) and
transformer (77) into a 220 V mains
supply, Fig 1.
Important:
components in special containers, Fig. 2.
ELECTRONIC MONITOR
To give you greater control over the
exercise, this electronic unit gives
simultaneous read-outs of speed and
rpm alternating with distance, exercise
time, calories burnt and pulse rate.
The screen will switch itself on
automatically as soon as you start
exercising or by pressing any key on
the monitor. The monitor switches on
as soon as you start to exercise on the
machine.
The monitor will switch itself off
automatically if the unit stands idle for
more than 4 minutes, with the screen
displaying the temperature.
A. SCAN FUNCTION
This function uses the large screen to
provide a sequential display of all the
values shown in the small windows, to
cancel this function press the MODE
key and the large screen will freeze
the value being displayed at the time
when the MODE key was pressed.
then plug
Deposit electronic
English
B. TIME FUNCTION
This function counts up or down in
steps of one second, up to a
maximum of 99:00 seconds.
1. Pressing the MODE key will select
the TIME window, the value to be
programmed will start flashing.
2. Pressing the SET key will display
the
the programmed exercise time.
3. Pressing the RESET key the
programmed exercise time will be
reset.
4. Begin the exercise and when the
time
elapsed the monitor will emit a beep
for 5 seconds, and the time will begin
to increase automatically.
C. DISTANCE FUNCTION
This function counts up or down in
steps of 0.5 km, up to a maximum of
99.5 km.
1. Pressing the MODE key will select
the DISTANCE window, the value to
be programmed will start flashing.
2. Pressing SET will display the
programmed exercise distance.
3. Pressing RESET the programmed
exercise distance will be reset.
4. Begin the exercise. When the
programmed distance has finished,
the monitor will beep for 5 seconds
and begin to increase the distance
automatically.
D. CALORIE FUNCTION
This function counts up or down in
steps of 10 calories, up to a maximum
of 999 kcal.
1. Pressing the MODE key will select
the CALORIES window, the value to
be programmed will start flashing.
7
that you programmed has