BH FITNESS H-6715 Manual De Instrucciones página 9

B.TIME FUNCTION
This function counts up or down in
steps of one second, up to a
maximum of 99:59 seconds. Pressing
the MODE key for more than two
seconds will reset all of the values,
except those relating to personal
information.
1. Press any key to switch the monitor
on.
2. Press the MODE key to start the
small TIME window flashing.
3. Press the UP or DOWN keys to
select the time.
4. Begin the exercise and the time
value will begin the countdown,
when it reaches zero it will beep for
3 seconds, advising you that the
selected time has elapsed, the time
value will
upward.
C.DISTANCE FUNCTION
This function counts up or down in
steps of 0.01 km/ml, up to a maximum
of 99.99 km/ml. Pressing the MODE
key for more than two seconds will
reset all of the values, except those
relating to personal information.
1.Press any key to switch the monitor
on.
2. Press the MODE key to start the
small DIST (DISTANCE) window
flashing.
3. Press the UP or DOWN keys to
select the distance.
4. Begin the exercise and the distance
value will begin the countdown,
when it reaches zero it will beep for
3 seconds, advising you that the
selected distance
covered, the distance value will
then start counting upward.
then start counting
has
D.CALORIE FUNCTION
This function counts up or down in
steps of one calorie, up to a maximum
of 9990 calories. Pressing the MODE
key for more than two seconds will
reset all of the values, except those
relating to personal information.
1. Press any key to switch the monitor
on.
2. Press the MODE key to start the
small
flashing.
3. Press the UP or DOWN keys to
select the calories.
4. Begin the exercise and the calorie
value will begin the countdown,
when it reaches zero it will beep for
3 seconds, advising you that the
selected calorie value has been
reached , the calorie value will then
start counting upward.
When the programmed calories have
finished, the monitor will beep for 3
seconds and begin to tally the new
calories burnt automatically.
E.PULSE FUNCTION
The pulse function shows you heart
beats per minute (BPM). To use this
function place your hands on the
handlebar sensors (R), Fig. 4, and
your heart rate will be displayed after
a few seconds. This is not a medical
appliance and therefore these values
are for guideline purposes only.
To select the THR (Target Heart Rate)
carry out the following steps:
1. Press any key to switch the monitor
on.
2. Press the MODE key to start the
been
small pulse window flashing and
THR will appear.
3. Press the UP or DOWN keys to set
the pulse rate value that you wish to
9
CAL (CALORIE) window