Cleaning And Maintenance - Baby auto DUPLA Duofix DS20 Manual De Uso

7. CAR SEAT FORWARD-FACING INSTALLATION.
GROUP 2/3
GROUP 2/3 only. From
NOTICE
4 years a 12 years (15-36 Kg)
1. Make sure the 5-point harness and harness buckle have been correctly
removed (see points 3.4).
2. Follow the steps described in section 3.9.
3. If you want to install the safety seat with the Isoclick Fix
the steps described in section 5.1.
7.1 Fastening the child in the seat. Group 2/3
4. Place the safety seat on the vehicle seat in the direction of travel.
5. Place the seat in the desired position (1, 2 or 3) (fig. 7.1).
6. Place the child in the seat. Pull the vehicle safety belt and pass it in front of
the child until it reaches the vehicle seat belt buckle.
IMPORTANT! Make sure the belt is not twisted.
7. Insert the clasp into the vehicle seat buckle. You should hear a click.
8. Place the diagonal part of the belt and the part that crosses the lap on the
side of the vehicle safety seat buckle, through the abdominal belt guide
of the safety seat (fig. 7.2 B).
9. Pass the diagonal part of the belt through the diagonal belt guide
the headrest until it is fully extended and not twisted (fig. 7.2 A).
10.Make sure the diagonal part of the belt passes over the child's collar bone
and not the neck.
IMPORTANT! The part of the abdominal belt should rest as low as possible
over the child's hips, on both sides.
TIP: If the seat back covers the guide (B), you can raise the headrest (A),
which will allow you to insert the diagonal section of the belt easily. You
should then reset the headrest to the correct height, as shown in point 3.9.
To ensure the child's safety, the following items should be checked before
every trip:
• The safety seat is well anchored.
• The part of the belt that crosses the abdomen passes through the
38
system, follow
®
(J)
(B) on
(J)
abdominal guides on both sides of the seat cushion.
• The diagonal section of the belt on the side of the vehicle belt buckle also
passes through the abdominal belt guide
• The diagonal section of the belt passes through the red clip (2) on the
headrest (B).
• The diagonal section of the belt passes diagonally towards the back.
• The straps are taut and not twisted.

8. CLEANING AND MAINTENANCE

1. Straps and plastic parts should be cleaned using a neutral detergent and
warm water.
2. Make sure soap does not enter the buckle or other metal parts.
3. Do not use chemical products or bleach on any part of the seat.
WASHING INSTRUCTIONS:
• The cover is removable and can
• For dry cleaning use
be washed at 30°. It should not be
any solvent except
machine dried.
trichloroethylene.
• Machine wash – Cold cycle.
• Do not use a drier.
• Do not bleach.
• Do not iron.
If you have any doubts or queries regarding the use or placement of this product
or you need any replacement elements, please contact our Customer Services
Department.
9. GUARANTEE
This product is covered by a legal warranty under the terms and conditions
in Royal Legislative Decree 1/2007, from the 16th of November. For a period
of 2 years after the date of purchase, any lack of conformity existing at the
time of delivery of the product is covered. It is essential to keep the purchase
ticket or invoice proving the purchase of the product within the warranty
period. The instructions for use given in the product manual must be followed
carefully for its start-up, as well as for the subsequent and proper operation
of the product. This warranty does not cover defects arising from accidental
deterioration, misuse, abuse of the product, improper maintenance, or repair
by unauthorised technical personnel or service, in which case the user shall
bear the costs of delivery and, where applicable, the repair. The warranty does
not cover consumable components, such as batteries or coatings exposed to
wear and tear, that are the result of normal use of the product.
(J) group on the seat cushion.
30 °C
39