Procedure To Install General Roll Media To The Take-Up Reel Unit - Oki H2P-74S Guía De Consulta Rápida

Procedure to install general roll media to the take-up reel unit

1
Prepare a paper tube and attach it to the
scroller flanges.
(1) Insert a scroller flanges into each edge of the paper
tube.
Scroller flange
(2) Insert the flange spacer between the scroller flange
and the media roll.
Note
- When PVC media is used, push the scroller flange until it
stops without inserting the flange spacer.
- The flange spacer should be inserted to the position
indicated by the line B.
Be careful not to deform it by applying too much force.
(3) Push the scroller flange until it stops and turn the
handle clockwise until the flange is fixed to the paper
tube.
Scroller flange
(4) Remove the flange spacers.
10 10
Paper tube
B A
Handle
2
Set the take-up direction switch to OFF.
Note
- If the printer processing proceeds to the next step with the take-
up direction switch set to ON, your hand may be caught as the
scroller is not secured.
3
Attach the scroller flange by fitting it with the
roller groove of the printer.
Roller groove
Note
- Hook the tension bar to the tension bar hook beforehand.
Tension bar hook
Tension bar
4
Feed the media with the FORM FEED MENU on
the operation panel to an extent where it can
be taken up.
Take-up direction switch
 Outer take-up
- OFF
OFF
 Inner take-up
Scroller flange