Oki H2P-74S Guía De Consulta Rápida página 9

11
Feed the media until the media end almost
reaches the floor.
In this state, smooth out the media toward the both
sides on the platen to make the media center tense.
Note
- If the media is set with a distortion or wrinkles, this may cause a
media jam or skew.
12
Feed back the media to the top of the front
paper guide.
Feed back the media while pressing the center of
the media gently at the supply side.
NOTICE
- Step 12 is important to set the media properly.
13
Rotate the pressure control knob in the arrow
direction to lower the pressure roller.
Takeup side
Pressure control knobs
8
Platen
Front paper guide
Supply side
or
14
Set the media edge guards and close the front
cover.
C H E C K E D G E G U A R D
* O K ?
Check that the media edge guards are not under the
media or thick media is not caught by inserting it
forcibly. After confirming visually that the media edge
guards are properly set, press the
15
Select roll media or cut-sheet media.
S E L E C T M E D I A
R O L L / S H E E T : R O L L
R O L L / S H E E T : S H E E T
Either [roll] or [sheet] can be selected with the
or key.
Here, select [roll] and press the
(To return to the media selection, press the
key.)
16
Select the type of media.
Select the registered type of media with the
keys and press the
S E L E C T M E D I A
M E D I A : T Y P E 0 2
M E D I A : T Y P E 0 2
To register new media
[NEW MEDIA ENTRY] is displayed at the end of the registered
media.
Press the key to enter MEDIA REG MENU.
The media registration procedure is the same as the registration
from the registration menu.
Press the key to return from the media registration menu to
the media type selection menu.
To return to the value before input, press the
S E L E C T M E D I A
M E D I A : T Y P E 0 2
M E D I A : T Y P E 0 2
(The registered media is displayed.)
S E L E C T M E D I A
N E W M E D I A E N T R Y
(Enter the media registration menu.)
key.
key
key.
CANCEL
and
key.
key.
CANCE L