Oki H2P-74S Guía De Consulta Rápida página 8

4
Attach the scroller shaft clip.
(1) Slip the scroller shaft clip on the scroller shaft.
(2) Turn the knob to fix the scroller shaft.
Scroller shaft clip
2
Knob
5
Install the media roll fitted with the scroller
flanges into the printer roller groove properly.
Scroller flange
Roller groove
6
Install the flange holders.
Cap side
7
Remove the protection bar and open the front
cover.
Protection bar
1
Printer rear (supply side)
Wiper side
Front cover
8
Move the media edge guards to each side so
that they are not under the media.
Media edge guards
9
Rotate the pressure control knob in the arrow
direction to raise the pressure roller.
Takeup side
Pressure control knobs
10
Insert the media end into the paper feeder
while smoothing out the media by hand to
prevent wrinkles.
Paper feeder
If it is hard to insert the media end into the paper
feeder due to a curl of the media, interpose an interleaf
and insert the media end under the interleaf as shown
in the figure.
- Up curl
Supply side
or
Printer rear
- Down curl
7