Supply Ink - Oki H2P-74S Guía De Consulta Rápida

Supply ink

At installing ink trays, be sure to insert each tray into its correct
slot position of the ink box.
Note that ink tray position is decided depending on its ink color.
LCD indication
R E M O V E
K 5 I N K P A C K
Slot position
Ink color
Note
- Do not remove ink tray in the following cases. Otherwise,
ink may spill in the Printer depending on the Printer
state, which may damage the Printer.
• The Printer is not powered on because the power was
interrupted or because the circuit breaker turned off the
Printer.
• An error other than ink end has occurred.
- Do not touch the contact point in the ink pack's plate.
K5
C6
M7
Y8
M2
Y1
Note
- Be sure to supply the ink in the corresponding reservoir.
- Otherwise different ink colors may be mixed together, or the ink
may spill out of the reservoir.
14
Ink color at 8-color
assignment
Slot position
Ink color at 4-color
assignment
K4
C3
Edge of the bulk ink system case
Note
- Do not supply more ink when the ink level inside a reservoir has
reached the FULL indication line. Otherwise, the ink may spill out
of the reservoir.
- Do not let the ink level go under the edge of the bulk ink system
case. If the reservoirs get empty, air will enter the ink tubes, which
may cause print defects.
- When it is difficult to see the level of ink inside the reservoirs
(for black or cyan color), you may compare the reservoir weight
with that of a reservoir containing a color easy to check, such as
yellow, to determine if ink needs to be supplied.
Follow the procedure below to replenish
the reservoirs with ink.
1
Remove the empty ink bottle from the
reservoirs.
Note
- It takes several minutes for the ink inside a bottle to
completely flow into the reservoir. Wait until the bottle is
completely empty before removing it from the reservoir.
(2)
Turn slowly the B part in the counter-clockwise
direction while holding the A part with your hand to
prevent it from turning.
FULL indication line
B
(1)
A