Periodic Maintenance; Maintenance Items Performed During Start Maintenance - Oki H2P-74S Guía De Consulta Rápida

Periodic maintenance

Maintenance items performed during start maintenance

Check media wrinkles
1
Check that the media is not wrinkled.
If it is wrinkled, either set the media again or feed it up
to an area without wrinkles.
* Printing on wrinkled media may damage the nozzle
surfaces.
C H E C K F O R
M E D I A W R I N K L E
Perform start maintenance
1
á R E W I N D F O R M F E E D â
ß P H . R E C
Press the key.
2
# S T A R T M A I N T E N A N C E
>
Execute [#START MAINTENANCE] to display
guidance for the following maintenance items.
Press the key to execute an item or the
CANCEL key to go to the next item.
Replace the spittoon case/unit
Replace the spittoon case approximately once every three
months depending on the amount of dirt on its surface. If a
spittoon unit and a tube set are available when replacing the
spittoon case, replace them at the same time. (The IP7-167
includes one spittoon unit and one tube for four spittoon cases.)
Replace also the spittoon absorber liquid at the same time.
Replace the spittoon case when:
- You find the ink clot accumulated on the spittoon case
surface; or
- The net is broken.
When replacing the spittoon case or unit from the operation
panel menu, start the procedure from step 1. When replacing
while executing [#START MAINTENANCE], start the procedure
in step 4.
You will be prompted to replace the spittoon case or unit during
the start maintenance guidance after 3 months or 2.5 km of print
length.
22
P H . M A I N à
1
á R E W I N D F O R M F E E D â
ß P H . R E C P H . M A I N à
Press the key.
2
# S T A R T M A I N T E N A N C E
>
key select [#MAINTENANCE].
With the
3
# M A I N T E N A N C E
> S P I T T O O N C A S E / U N I T ?
Select [SPITTOON CASE/UNIT] and press the
key.
4
O P E N C O V E R
Open the front cover.
5
S P I T T O O N R E P L A C E D ?
Y E S : O K / N O : C A N C E L
After you have finished the replacement
procedure described from step 6, press the
key.
6
Open the front cover and then open the capping
cover.
7
Replace the entire spittoon unit if one is
available.
If not available, continue the procedure from
step 9.
Remove the knob screw of the spittoon unit and
remove the spittoon unit.
Spittoon unit
Knob screw