Oki H2P-74S Guía De Consulta Rápida página 19

3
# S E T I N K S U P P L Y ( m l )
# C C C : X X X X >
Select REMAINING INK with the
4
# R E M A I N I N G I N K
> X X . X L
Check the remaining ink amount that can be
used.
Select EXTEND INK AMOUNT with the
keys.
5
# E X T E N D I N K A M O U N T
>
Press the key twice.
6
S E T I N K E X T E N S I O N
C H I P T O C H I P R E A D E R
Insert the ink extension chip into the chip reader.
Press the
CANC E L
7
P R O C E S S I N G . . .
Wait for a while.
Do not remove the chip while PROCESSING... is
displayed. Wait until a sound is emitted and the
display changes indicating that the process is
complete.
8
R E M O V E
I N K E X T E N S I O N C H I P X
Remove the ink extension chip from the chip
reader.
If a read error occurs, one of the following numbers is
displayed in the panel bottom right corner.
1: The chip has already been used.
2: The chip has not been recognized as an ink extension chip.
A chip can be used only once. Do not store used chips
with new ones.
You can check the content of chips that could not be
recognized using the READ EXTENSION CHIP command.
See Check the ink extension chip information in the
Advanced Operation Guide for the procedure.
18
, keys.
,
key if the chip is not read.
9
S E T I N K E X T E N S I O N
C H I P T O C H I P R E A D E R
Ink extension chips can be read successively.
Press the key if you have finished reading
CANCEL
chips.
10
# E X T E N D I N K A M O U N T
>