Storage; Transport; Care And Maintenance; Maintenance Intervals - Kärcher HDS 3.5/23-4M Eg Manual De Instrucciones

Ocultar thumbs Ver también para HDS 3.5/23-4M Eg:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Shutdown
For longer work breaks or if a frost free stor-
age is not possible:
 Empty detergent tank.
 Drain water.
 Flush device with anti-freeze agent.
Dump water
 Screw off water supply hose and high
pressure hose.
 Screw off supply hose at boiler bottom
and drain heating spiral empty.
 Operate device for max. 1 minute until
the pump and conduits are empty.
Flush device with anti-freeze agent
Note: Observe handling instructions of the
anti-freeze agent manufacturer.
 Fill anti-freeze agent of the trade into
swimmer container.
 Switch on appliance (without heater) till
the appliance has been completely
rinsed.
A certain corrosion protection is achieved
with this as well.

Storage

CAUTION
Risk of personal injury or damage! Consid-
er the weight of the appliance when storing
it.

Transport

Figure 9
ATTENTION
Risk of damage! When loading the appli-
ance with a forklift, observe the illustration.
ATTENTION
Protect the trigger from damage during
transport.
CAUTION
Risk of personal injury or damage! Mind the
weight of the appliance during transport.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
16
All manuals and user guides at all-guides.com
Risk of injury by inadvertent start-up of ap-
pliance and electric shock. Prior to all work
on the appliance, switch off the appliance
and pull the power plug.
 Shut off water supply.
 Open the hand spray gun.
 Switch on the pump with the power
 Close the hand spray gun.
 Set the appliance switch to "0/OFF".
 Pull main plug out of socket with dry
 Remove water connection.
 Activate hand spray gun until device is
 Secure the trigger gun. To do so, push
 Allow device to cool down.
Your Kärcher vender will inform you
about the performance of a periodic
safety inspection resp. signing of a
maintenance contract.
Weekly
 Clean the sieve in the water connection.
 Clean the fine filter.
 Check oil level.
ATTENTION
Risk of damage! In case of lacteous oil in-
form Kärcher customer service immediately.
Monthly
 Clean sieve in the water shortage safe
 Clean filter at the detergent suck hose.
Every 500 operating hours, at least
annually
 Oil change.
 Have the maintenance of the device
At least every 5 years, recurring
 Perform the pressure test as per manu-
– 9
EN

Care and maintenance

DANGER
switch and allow to run for about 5-10
seconds.
hands only.
pressure less.
the safety catch towards the front.

Maintenance intervals

guard.
performed by the customer service.
facturer's instructions.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Hds 3.5/30-4m eaHds 4.0/20-4m eaHds 4.5/22-4m ea

Tabla de contenido