Oncue Plus Generator Management System - Kohler 14/20RESA Manual Del Usuario

1.12.7 OnCue Plus Generator
Management System
The OnCuer Plus Generator Management System
allows monitoring and control of your generator set from
a personal computer, smart phone, or tablet. OnCue
Plus can also be configured to send email or text
message notifications in the event of a generator set
fault. Both a network cable connection version (OnCue
Plus) and a wireless version (OnCue Plus Wireless)
are available. See TP-6928, OnCue Plus Operation
Manual, for instructions.
Note: Wireless connection of the generator is only
available with the purchase of OnCue Plus
Wireless.
OnCue Plus
OnCue Plus is available separately as a loose kit. Use
category 5E network cable to connect the RDC2
controller to the customer-supplied Ethernet router or
modem. Route the cable with other low-voltage signal
wiring (for example, the RBUS communication leads or
engine start leads to the transfer switch), in separate
conduit from the AC load leads. If the network cable is
longer than 100 meters (328 ft.), use a repeater or
switch.
Recommended: Use a laptop computer to verify the
network connection before connecting to the generator
set.
Checking the network connection
1. Check for and turn OFF any wireless connections
to the laptop.
2. Connect the network cable to the laptop. Connect
the other end of the network cable to the
customer's router or modem.
3. Verify the Internet connection by opening your web
browser and going to www.kohlerpower.com or
any known website.
4. After verifying the connection through the network
cable, disconnect the network cable from the
laptop and turn the laptop wireless connections
back on.
40 Section 1 Installation
All manuals and user guides at all-guides.com
Connect to the Ethernet cable in the customer
connection area of the generator set. See Figure 1-45.
Use an RJ45 inline coupler, provided with the OnCue
Plus kit, to connect the customer's Ethernet cable to the
cable in the customer connection box.
Figure 1-45 Network Connection for OnCue Plus
OnCue Plus Wireless
The OnCue Plus Wireless kit allows connection of the
generator set to the Internet through the customer's
wireless router without running a network cable from the
generator to the customer's Ethernet router.
OnCue Plus Wireless kit includes OnCue Plus and a
wireless access point that mounts inside the generator
enclosure. Follow the instructions in TT-1618, provided
with the kit, to install and set up the wireless access
point.
Figure 1-46 Typical OnCue Plus Wireless Access
1
1. Ethernet cable for optional OnCue Plus connection
1
1. OnCue Plus wireless access point
Point Installation
GM84094
The
GM81385
TP-6803 1/15