Regulator Heater - Kohler 14/20RESA Manual Del Usuario

Ocultar thumbs Ver también para 14/20RESA:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 126

1.12.4 Regulator Heater

WARNING
Hot engine and exhaust system.
Can cause severe injury or death.
Do not work on the generator set until
it cools.
Servicing the engine heater. Hot parts can cause minor
personal injury or property damage. Install the heater
before connecting it to power. Operating the heater before
installation can cause burns and component damage.
Disconnect power to the heater and allow it to cool before
servicing the heater or nearby parts.
The optional regulator heater kit is designed for Model
20RESA and 20RESAL generator sets. The regulator
heater kit is recommended in addition to the carburetor
heater for reliable engine starting in temperatures below
--18_C (0_F). See Figure 1-35 for heater specifications.
Order the 120 V or 240 V kit as appropriate for your
application. See specification sheet G6-126 for kit
details.
120 V Kit
Heater rating
120 VAC, 60 W
50/60 Hz
Thermostat
4
C/13
_
_
Pad diameter
Cord length
Figure 1-35 Regulator Heater Specifications
The fuel regulator heater is a 127 mm (5 in.) diameter
round heating pad with a snap action thermostat and a
power cord. Figure 1-37 and Figure 1-36 show the
heater installed on the fuel regulator, which is located on
the air intake side of the generator set. To install the
regulator heater kit, follow the instructions in TT-1569,
provided with the kit.
TP-6803 1/15
All manuals and user guides at all-guides.com
240 V Kit
240 V, 100W
50/60 Hz
(
C
40
F/55
F) Snap action
_
_
127 mm (5 in.)
610 mm (24 in.)
The fuel regulator heater requires a source of AC power.
Verify that AC power is connected to the generator set
as described in Section 1.9. The circuit must be backed
up by the generator set to provide power at all times.
120 VAC generator sets are equipped with one or two
120 VAC receptacles. A receptacle adapter is included
in the 120 volt heater kit to allow more than one
accessory to be plugged into the receptacle.
240 volt heater kits use a 3-pin power connector.
Generator sets built after 10/9/2013 with serial numbers
SGM327VFJ or later have a knockout under the
controller for the 240 VAC power connector. 240 volt
fuel regulator heater kits include an adapter harness to
allow connection of two AC accessories.
Knockout Detail
Note:
Adapter harness for multiple accessories not shown.
1. 240 VAC power connection (see knockout detail)
2. Fuel regulator heater pad
Figure 1-36 Model 20RESA/RESAL 240 Volt Kit
Power Connection
1
2
GM79141-E
Section 1 Installation
35

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

14/20resal

Tabla de contenido