Rdc2 Controller Menus; Main Menu - Kohler 14/20RESA Funcionamiento

3.7 RDC2 Controller Menus

Controller menus display power system information,
including status information for the engine, generator,
and optional RBUS accessories, exercise settings, and
event history. Some menus allow changes to the
controller settings. Status information, including the
engine runtime, cannot be changed by the operator.
Diagrams in the following sections show how to
navigate through the menus.
sample settings. Settings for your application may vary.
Note: Use caution when navigating the controller
menus. In some menus, pressing the Select
button can enable editing of the controller
settings. Changing the settings to incorrect
values can adversely affect generator set
operation or render the unit inoperable.
38 Section 3 RDC2 Controller Operation
The diagrams show
If a setting on the controller display is flashing, edit mode
has been enabled. Press the OFF or AUTO button to
exit the edit mode.

3.8 Main Menu

Press the Select button once to bring up the main menu.
Overview is displayed. See Figure 3-9. Press the down
arrow button to step to the next menu, Engine Metering.
Use the UP and DOWN arrow buttons to step up and
down through the menus shown in Figure 3-9.
The controller will exit the main menu after 5 minutes if
no buttons are pressed.
immediately, press the controller's OFF or AUTO
button.
To exit the main menu
TP-6804 1/15