3.18.1 Networking Status Submenu
The Networking Status submenu contains settings for
OnCuer. Changes to these settings are not typically
required.
If DHCP is enabled, IP parameters are not displayed. If
DHCP is disabled (i.e., if a static IP address is used), the
IP parameters are displayed.
Networking---->
Information
Figure 3-20 Network Status Submenu
TP-6804 1/15
To enable or disable DHCP and change the IP settings,
go to the Networking Configuration menu.
Section 3.18.2.
Networking---->
Status
OnCue Status:
Connected
DHCP:
Enabled
IP Address:
123.456.789.123
Subnet Mask:
123.456.789.123
Gateway:
123.456.789.123
DNS 1:
123.456.789.123
DNS 2:
123.456.789.123
Ethernet Status:
Disconnected
OnCue Server:
123.456.789.123
<---- Return
Section 3 RDC2 Controller Operation
See
tp6804
47