Kohler 14/20RESA Funcionamiento página 37

1. Press the Select button to enter the main menu.
Press: Display:
2. Press the down arrow button until the desired
menu is displayed. See Figure 3-9. Date and Time
are used for this example.
Press: Display:
3. Press the Select button to enter the Date and Time
menu.
Press: Display:
4. To change the date and time settings, press the
Select button again. The year will flash.
Press: Display:
5. Press the up or down arrow buttons to change the
year.
Press: OR
6. When the correct year is shown, press the Select
button. The year is saved and the next setting
(month) flashes.
Press: Display:
7. Repeat steps 5 and 6, using the arrow and select
buttons to set the month and the date.
Figure 3-7 Changing Settings
TP-6804 1/15
Changing Settings on the RDC2 Controller
Overview ---->
1.2 h
Date ---->
and Time
Date:
05Dec2011
Date:
05Dec2011
Date:
Display:
05Dec2012
Date:
05Dec2012
8. When the correct date is shown, press the Select
button. The saved date is shown.
Press: Display:
9. Press the down arrow button to step to the next
menu.
Press: Display:
10. Repeat steps 5 and 6, using the arrow and select
buttons to set and save the time.
Note: To change from am to pm, press the up arrow
key to increase the hour until the correct hour
and pm is displayed.
11. In the time format menu, press Select and then
press the up or down arrow button to change the
format, 12 hr. or 24 hr. Press Select to save the
displayed format.
12. Press the down arrow button.
displayed.
Press: Display:
13. Press Select to return to the Date and Time
menu.
Press: Display:
14. Press the Up or Down arrow buttons to step to a
different menu.
15. Press Auto to signal the controller to exit the
menus and return to the generator set status
display.
Display:
Press:
AUTO
Note: If no buttons are pressed, the controller returns
to the status display after 5 minutes.
Section 3 RDC2 Controller Operation
Date:
03Jan2012
Time:
01:49pm
Return is
<---- Return
Date ---->
and Time
Genset State
Standby
35