Specifications; Stihl Fsa 130 Trimmer - Stihl FSA 130 Manual De Instrucciones

19 Specifications

Fault LEDs on the
battery
3 LEDs flash
red.
3 LEDs light
up red.
4 LEDs fla‐
shing red.
The brushcutter 3 LEDs light
cuts out during up red.
operation.
The runtime of
the brushcutter is
too short.
19 Specifications
19.1

STIHL FSA 130 Trimmer

Approved batteries:
– STIHL AR
– STIHL AP together with "AP belt bag with
connecting cable"
– Weight without cutting attachment and deflec‐
tor: 4.5 kg
– Length without cutting attachment: 1750 mm
For battery life see www.stihl.com/battery-life.
0458-726-9821-D
Cause
The brushcutter has a
malfunction.
The brushcutter is too
hot.
There is a fault in the
battery.
No electrical contact
between brushcutter
and battery.
The brushcutter or
battery is damp.
The brushcutter is too
hot.
There is an electrical
fault.
The battery is not fully
charged.
The battery life has
been exceeded.
19.2
K-value (uncertainty) for sound pressure levels is
2 dB(A). K-value (uncertainty) for sound power
levels is 2 dB(A). The K-value for vibration level
is 2 m/s².
STIHL recommends wearing ear defenders.
Using with a mowing head
– Sound pressure level L
to EN 50636‑2‑91: 83 dB(A)
– Sound power level L
EN 50636-2-91: 94 dB(A)
Remedy
► Pull connecting cable plug out of the
socket and plug in again.
► Switch on the brushcutter.
► If 3 LEDs continue to flash red: Do not
use your brushcutter and contact your
STIHL dealer for assistance.
► Pull the connecting cable plug out of the
socket.
► Allow the brushcutter to cool down.
► Pull connecting cable plug out of the
socket and plug in again.
► Switch on the brushcutter.
► If 4 LEDs continue to flash red: Do not
use the battery and contact your STIHL
dealer for assistance.
► Pull connecting cable plug out of the
socket and plug in again.
► If the brushcutter still does not start
when switched on: Clean the contacts of
the connecting cable as described in the
STIHL AR battery's user manual or in
the user manual for the "AP belt bag with
connecting cable".
► Allow the brushcutter or battery to dry.
► Pull the connecting cable plug out of the
socket.
► Allow the brushcutter to cool down.
► Pull connecting cable plug out of the
socket and plug in again.
► If the brushcutter continues to cut out
during operation: Clean the contacts of
the connecting cable as described in the
STIHL AR battery's user manual or in
the user manual for the "AP belt bag with
connecting cable".
► Switch on the brushcutter.
► Recharge the battery fully as described
in the User Manual for the STIHL AL
101, 300, 500 chargers.
► Replace battery.
Sound Values and Vibration
Values
pA
measured according to
wA
English
measured according
41