Removing And Installing Metal Cutting Attachment; Removing The Metal Cutting Attachment; Adjusting Trimmer For User; Using With Stihl Ar Battery - Stihl FSA 130 Manual De Instrucciones

7 Adjusting Trimmer for User

► Rotate the mowing head (1) counterclockwise
until the stop pin (4) engages in position.
The shaft is now blocked.
► Tighten down the mowing head (1) firmly by
hand.
► Remove the stop pin (4).
6.4.2 Removing the Mowing Head
► Switch off the trimmer and pull the connecting
cable plug out of the socket.
► Insert the stop pin in the bore as far as stop
and hold it depressed.
► Rotate the mowing head (3) until the stop pin
engages in position.
The shaft is now blocked.
► Unscrew the mowing head clockwise.
► Remove the thrust plate.
► Remove stop pin.
6.5 Removing and Installing Metal
Cutting Attachment
6.5.1 Mounting Metal Cutting Attachment
► Switch off the trimmer and pull the connecting
cable plug out of the socket.
► Place the thrust plate (5) on the shaft (6) so
that its smaller diameter faces up.
► Place the metal cutting attachment (4) on the
thrust plate (5). If you are fitting a circular saw
blade or a grass cutting blade with more than
4 cutting edges: Its cutting edges must face in
the same direction as the arrow on the deflec‐
tor.
► Place the thrust washer (3) on the metal cut‐
ting attachment so that its raised side faces
up.
0458-726-9821-D
► Place the rider plate (2) on the thrust washer
► Insert the stop pin (7) in the bore as far as
► Rotate the metal cutting attachment (4) clock‐
► Fit the nut (1) counterclockwise and tighten it
► Remove the stop pin (7).
6.5.2
► Switch off the trimmer and pull the connecting
► Insert the stop pin in the bore as far as stop
► Rotate the metal cutting attachment clockwise
► Unscrew the mounting nut clockwise.
► Remove the rider plate, thrust washer, metal
► Remove stop pin.
1
7.1
2
7.1.1
3
The connecting cable can be fitted and adjusted
to suit the user's size and the application.
4
5
6
7
The connecting cable can be secured in position
by the guide (1) on the harness and the fasten‐
ers (2), or on the side of the backplate with the
fasteners (2).
(3) so that its closed side faces up.
stop and hold it depressed.
wise until the stop pin (7) engages in position.
The shaft is now blocked.
down firmly.
Removing the Metal Cutting Attach‐
ment
cable plug out of the socket.
and hold it depressed.
until the stop pin engages in position.
The shaft is now blocked.
cutting attachment and thrust plate.
7 Adjusting Trimmer for User

Using with STIHL AR Battery

Fitting and Adjusting the Connecting
Cable
1
2
2
2
English
2
2
2
33