Checking Brake Fluid Level - APRILIA SCARABEO 500 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1
-MIN-
NOTE
This vehicle is fitted with front and
rear disk brakes. Each braking system is
operated by an independent hydraulic
circuit. The information provided below
applies to both braking systems.
Brake fluid level decreases gradually as
the brake pads wear down.
The brake reservoirs are placed under the
handlebar cover, near the brake lever
connections.
Check brake fluid level in the reservoirs at
regular intervals - see (CHECKING
BRAKE FLUID LEVEL) at the side - and
inspect the brake pads periodically for
wear, see page 50 (CHECKING THE
BRAKE PADS FOR WEAR).
WARNING
Do not ride if the braking system is
leaking.
28
use and maintenance Scarabeo 500
All manuals and user guides at all-guides.com

CHECKING BRAKE FLUID LEVEL

Check level as follows:
NOTE
Place the vehicle on firm, level
ground.
Place the vehicle on the centre stand.
Turn the handlebar. The fluid in the
reservoir must be parallel with the "MIN"
mark on the sight glass (1).
Ensure that fluid level in the reservoir is
above the "MIN" mark on the sight glass
(1).
MIN = minimum level.
CAUTION
Do not ride when brake fluid level is
below the "MIN" mark.
CAUTION
Brake fluid level decreases gradually as
the brake pads wear down.
Check the brake pads and brake disk for
wear, see page 50 (CHECKING THE
BRAKE PADS FOR WEAR).
If the brake pads and/or the brake disk are
in good condition:
Contact an aprilia Official Dealer and
have brake fluid level topped up.
WARNING
Check braking efficiency.
When the brake lever has exceeding
travel or if you notice a loss of braking,
contact an aprilia Official Dealer. The
braking system may need bleeding.

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido