Modbus Set - Carrier 40VCC727FQEE Manual Del Propietario Y De Instalación

k Add and delete button: Click "-" to enter the delete timing setting interface.
You can select the icon that is set as "invalid". After selecting it, click "Complete" to delete the selected setting. Click
"Cancel" to abandon the current setting.
l Click on the "Fully open" and "Fully closed" button to switch the current energy saving setting to enable the deactivation
state.

3.27 Modbus Set

Modbus sets the switches used for configuring the third-party de-control interface.
The associated hardware interface is "COM5". The other parameters are default values and cannot be modified.
You can choose to turn it ON or OFF.
The following parameters are default and are not editable :
Baud rate: 9,600
Data bit: 8bits
Stop bit: 1bits
Check mode: no parity
This function only supports "On/Off".
74