Cold Air Distribution And Circulating Air Return Feed; Cold Air Distribution; Circulating Air Return; Installing The Infra-Red Receiver - Truma Saphir vario Instrucciones De Uso

Cold air distribution and circulating air
return feed

Cold air distribution

A KR 65 Ø 65 mm (8) cold air duct with at least one outlet
must be connected to each of the three cold air emitters of
the unit (5, 6 and 7).
Slide the cold air ducts (8) into the cold air emitters of the unit
and route to the air outlet nozzles. Truma can supply a sound
muffler for installing in the cold air system (part no. 40040-
60100) as an accessory for reducing the noise level.
The RL rectangular air outlets (part no. 40280-01) with the
ANH connecting piece (part no. 40920-02) are particularly
suitable for use as cooled air outlets into the vehicle interior.
The cold air distribution system is individually designed
for each vehicle model using a modular principle. A wide
range of accessories is available for this purpose.
In order to achieve the best possible cooling power, we
recommend:
– Route cold air pipes to air vents as short and straight as
possible.
– The total accumulated length of cold air duct that may be
used is 15 m.
– Connect the longest cold air duct (max. 8 m) to the marked
cold air outlet (q), since this has the most air throughput.
– To prevent condensation, do not route cold air ducts in the
vicinity of incoming outside air (or behind the refrigerator).
q

Circulating air return

The circulating air is drawn in again by the unit, either through
an additional rectangular air grille (1 – part no. 40040-29200)
or 3 round air grilles (part no. 40040-20400), e.g. in the stow-
age box wall or via several smaller openings with a total area
of at least 300 cm².
Important note
To ensure trouble-free air exchange, the air infeed from the
interior of the vehicle to the installation location must be
located in the immediate vicinity of the device. If appropri-
ate, covers are to be fitted, in order to avoid the circulating air
return being impeded by stowed objects.
If the equipment cannot be installed in close proximity,
Truma can provide a flexible air intake (part no. 40090-
59100) as an accessory.

Installing the infra-red receiver

The receiver (9) is to be fitted for preference on the clothes
cabinet in such a way that the remote control can be pointed
at it without any hinderance (length of connection cable 3 m).
If necessary, a 3 metre cable extension can be supplied
(part no. 40090-89100).
If the receiver cannot be flush-mounted, Truma can
provide an on-surface frame (10 – part no. 40000-52600)
as an accessory if required.
Drill a hole 55 mm in diameter. Lead the cable through from
behind and secure the receiver with 4 screws (11). Then at-
tach the cover frame (12), route the cable to the air condition-
ing unit and connect to the unit at the side.
5 5
Ø
10
Truma offers side parts (13) in eight different colors for
finishing the cover frames (12) in a visually pleasing way.
Please ask your dealer.
m
m
9
11
13
12
13
19