Mixing Oil Tank; Starting The Engine; Cold Engine Starting; Stopping The Engine - SHERCO 50 SE 2022 Manual Del Propietário

UTILISATION DU VÉHICULE

MIXING OIL TANK

To refill, remove the tank cap (p.72).
Tank capacity is recorded at (p.66).
After refilling, screw the cap back on.
Use the oil indicated on page 16 in the "Lubricants and Recommended Fluids" table.

STARTING THE ENGINE

Rotate the fuel tap to either ON or RES (p.72).
Check that the gearbox is in neutral (p.74).
Pull in the clutch lever (p.73).
Take the bike off the side stand.
To start the engine, rotate the Kickstarter lever outward and give it a sharp blow down.
WARNING
Once the Kickstarter pedal is depressed, release it immediately. This avoids shocks to the whole starting system and the operators foot.

COLD ENGINE STARTING

Activate the choke by pushing it (p.73), start the vehicle, wait a few seconds and then return the lever to
the initial position.

STOPPING THE ENGINE

To shut down the engine, perform the following operation:
- turn the key to the off position
NOTE
When the engine is off, always turn the fuel valve to the OFF position (
(p.75).

p.72).
81