Viking MR 4082 Manual De Instrucciones página 108

Remove the cap (3). Unscrew the
connection of the red connection cable (4)
from the battery positive (+) terminal using
two A/F 8 spanners and remove the screw,
washer and nut.
Detach and remove the connection cable
(4) from the battery positive (+) terminal.
● Remove the battery if necessary.
( 14.20)
● Reattach screws, washers and nuts to
the battery negative (–) and positive (+)
terminals for safe keeping.
● Install the steering column cover if
necessary. ( 14.18)
Connecting the battery:
● Check the battery voltage before
installing the battery. If the minimum
voltage is not achieved, fully recharge
the battery using a battery charger
before installation.
Minimum voltage: 11,5 V
● Insert the battery.
● If necessary, remove the screw, washer
and nut from the battery.
106
Attach the terminal connector of red
connection cable (4) to the battery
positive (+) terminal.
Tighten the connection cable with
screw (5), washer (6) and nut (7) using
two A/F 8 spanners.
Tightening torque: 4 - 5 Nm
Fit cap (3) onto the connection.
Attach the terminal connector of black
connection cable (2) to the battery
negative(–) terminal.
Tighten the connection cable with
screw (5), washer (6) and nut (7) using
two A/F 8 spanners.
Tightening torque: 4 - 5 Nm
Removing the battery:
● Remove the steering column cover.
( 14.17)
● Disconnect the battery. (
Open the retaining clasp (1) Remove the
battery (2).
● Close the retaining clasp.
● Install the steering column cover.
( 14.18)
Inserting the battery
● Remove the steering column cover.
( 14.17)
0478 193 9902 A - EN
14.20)