Other Information; Technical Data - AL-KO E.C.S 12 Manual Del Usuario

All manuals and user guides at all-guides.com

10. Other Information

10.1 Fuse change
The control unit is protected by a fuse element (FK 2 flat fuse).
The fuse element including the spare fuse is located on the reverse of the control device
foto 1020:
Spare fuse
Red "cable
link"
To do this, switch the system off.
•
Remove the fuse
•
Replace the faulty fuse with a new fuse (spare fuse) of the same rated current power (20
Amp).
If the newly inserted fuse burns out again after a brief period of time, then the system must be
checked by a specialist workshop.
Only use flat fuses with the current strength specified!
Do not "repair" fuses or replace them with stronger ones, this could lead to damage to the
electrical system.
Important electronic components can be damaged or their function be effected in a negative
manner.
FIRE HAZARD!

10.2 Technical data

Never subject the control or remote control to the following influences:
Heat sources, direct sunlight or other electrical equipment.
Protect the control and remote control from damp, dust, aggressive liquids and vapours.
Hand transmitter:
Range:
Dimensions:
Weight:
Batteries:
Frequency
Band width:
Flat fuse
Approx. 10 m (dependent on location and the battery capacity)
l x w x h 120mm, 57mm, 27mm
80g
2 x 1.5V Micro LR 03 AAA Do not use rechargeable batteries!
868.3 MHz
+/- 300KHz
19