Display Of Operating Data And Counters - Sime BRAVA SLIM HE 25/55 Manual De Instalación Y Mantenimiento

EN
– as a precautionary measure, close the gas isolation valve.
Repair the fault and start-up the boiler again.
after having repaired the fault, when the alarm number
NOTE:
appears on the display together with the message
(see figure), press the button
to start the appliance up again.
3.5

Display of operating data and counters

Once the boiler is operating a qualified technician can view the
operating data and the counters as follows:.
From the operating screen in the mode enabled at that moment
(WINTER n or SUMMER l
– go into "DISPLAY" by pressing the buttons
for more than 3 seconds until the following screen
same time
appears
From this point, the technician has 2 options:
– scroll through the list of "information (PAR)" and "counters
by pressing the button
(PARc)"
d
y for approximately 3 seconds
):
r and <
at the
t . Scrolling will be in sequence
– display the "activated alarms" (no more than 10) by pressing
the button r
– Once in this section, proceed with button
When all the values have been displayed, exit the menu by
pressing and holding down the button
seconds until the initial screen is displayed.
TABLE OF INFORMATION DISPLAYED
Type No. Description
PAR 00 SW version
External
PAR 01
temperature sensor
Delivery sensor
PAR 02
temperature
PAR 03 Smoke probe
Domestic hot water
PAR 04
sensor temperature
PAR 05 AUX auxiliary sensor - 9 .. 99
Actual heating SET
PAR 06
temperature
PAR 07 Power level
PAR 08 Flow meter rate
Water pressure
PAR 09
transducer reading
Display of current
PAR 10
fan revolutions
t or r .
y for approximately 5
Range U/M Step
- 9 .. 99 °C 1
- 9 .. 99 °C 1
- 9 .. 99 °C 1
- 9 .. 99 °C 1
°C 1
Par. 13
... Par. °C 1
14
0 .. 99 % 1
0 .. 99 l/min 0.1
0 .. 99 bar 0.1
RPM x
0 .. 99 1
100
91