Starting And Stopping - Maruyama BT230L Manual Del Propietario U Operador

For your fuel premix, use MARUYAMA
Premium two-stroke Oil Mix, or equivalent
ISO-L-EGD & JASO FD oil with a minimum
89 octane high quality gasoline. MARUYAMA
two-stroke oil is specially formulated to meet
the requirements of high-performance,
low-emission air-cooled two-stroke engines.
Use of other oils may lead to service issues
which may not be covered by your warranty.
Fuel Mixture
The fuel: oil ratio is 50 parts gasoline to 1 part oil or
50:1.
NOTE: Never use a mixing ratio less than
50:1 regardless of the oil package mixing
instructions. Ratios less than 50:1, (for example,
60:1, 80:1, 100:1), reduce the amount of lubrica-
tion to the internal mov ing parts of the
engine and can cause damage.
Fuel Mixture Chart
Gasoline
1 gallon
2 gallons
5 gallons
1 liter
5 liters
Mixing Instructions
IMPORTANT: Never mix gasoline and oil
directly in the Trimmer fuel tank.
1. Always mix fuel and oil in a clean container
approved for gasoline.
2. Mark the container to identify it as fuel mix for
the Trimmer.
50:1
50:1 two-stroke oil
2.6 oz
.
5.1 oz.
12.8 oz.
20 mL
100 mL
— US-14 —
3. Use regular unleaded gasoline and fill the container
with half the required amount of gasoline.
4. Pour the correct amount of oil into the container
then add the remaining amount of gasoline.
5. Close the container tightly and shake it momentarily
to evenly mix the oil and the gasoline before
filling the fuel tank on the Trimmer.
6. When refilling the Trimmer fuel tank, clean
around the fuel tank cap to prevent dirt and debris
from entering the tank during cap removal.
7. Always shake the premix f uel container
momentarily before filling the fuel tank.
8. Always use a spout or funnel when fueling to
reduce fuel spillage.
9. Fill the tank only to within 1/4-1/2 in. (6 mm-13
mm) from the top of the tank. Avoid filling to the
top of the tank filler neck.

Starting And Stopping

Before Starting The Engine
1. Fill the fuel tank as instructed in the Before
Operation section of this manual (US-12).
2. Rest the Trimmer on the ground.
3. Make sure the cutting attachment is clear of any
broken glass, nails, wire, rocks or other debris.
4. Keep all bystanders, children and animals away
from the working area.