Cutting With Trimmer Head - Maruyama BT230L Manual Del Propietario U Operador

Cutting with Trimmer Head

• The tip of the line does the cutting. The line
should stay extended while cutting.
Three inches
(7.6 cm) Above
Ground
CORRECT
• Do not force the line into the material. Forcing the
line will cause it to slap against the material,
increasing line usage and causing poor cutting
results.
INCORRECT
Trimming
Hold the bottom of the trimmer head about 3 in. (7.6
cm) above the ground and at an angle. Allow only the
tip of the line to make contact.
Scaling
To remove unwanted vegetation, hold the trimmer head
about 3 in. (7.6 cm) above the ground and at an angle.
Allow the tip of the line to strike the ground cutting the
vegetation off at the surface.
Mowing
Keep the line parallel to the ground and use a gentle
side-to-side motion.
— US-18 —
Three inches
(7.6 cm)
Above Ground
Three inches
(7.6 cm)
Above Ground