Fault Messages - Miele Scout RX1 / 1115 Instrucciones De Manejo

The robot vacuum cleaner is not
charging.
The base station / robot vacuum
cleaner is not connected to the
electricity supply correctly. Connect the
base station exactly as described in
these operating instructions. Do the
same for the robot vacuum cleaner, see
"Preparing for use - Charge the
rechargeable battery").
The robot vacuum cleaner does not
return to the base station after
vacuuming.
The Auto standard vacuuming mode
was started somewhere in the room.
The robot vacuum cleaner will return to
its starting point.
When the Spot vacuuming mode is
selected the robot vacuum cleaner
returns to its starting point.
There is insufficient light for the robot
vacuum cleaner to navigate - provide
sufficient lighting.
The base station is not connected
correctly. Connect the base station
exactly as described in these operating
instructions.
The sensors on the robot vacuum
cleaner are dirty. Clean them carefully
using a dry cotton wool bud.
The connection from the infrared
transmitter on the base station to the
vacuum cleaner is broken. Clean both
parts carefully with a soft, dry cloth and
make sure that no items disrupt the
connection.
Obstacles on the floor which is to be
vacuumed can impede navigation.
Watch the robot vacuum cleaner during
vacuuming to identify and remove any
problematic obstacles, define the area
they are in with the magnetic strip or
reduce the maximum crossing over
height, see "Use - Reducing the
maximum crossing over height".

Fault messages

,
Before resolving any faults with
the robot vacuum cleaner, switch it
off with the OFF switch on the side.
Fault messages are shown in the clock
indicator of the robot vacuum cleaner's
display.
F 1 "Wheel raised"
Place the robot vacuum cleaner
on a level floor surface.
F 2 "Dirty sensors"
Clean the sensors.
This fault message will also
appear if the side brushes are not
fitted. In this case, fit the side
brushes.
F 3 "Dust box"
Insert the dust box into the robot
vacuum cleaner making sure it
clicks into position.
F 4 "Drive wheels overloaded"
Check whether the drive wheels
have become dirty. Remove any
threads and hairs.
en
51